New Boomershoot steel

Last weekend I installed some new steel targets for Boomershoot at the 375 yard tree line.

Here is the old steel (picture from last December):

20181216_094114

The targets were made and donated by an extremely generous Boomershooter. They thought they were doing the right thing by making the targets out of soft steel. The thinking was that this would prevent ricochets. It turns out this is not the way to do it. The steel becomes cratered:

20181216_094125

The craters cause the bullets fragments to spray back at the shooter and large fragments can travel dozens of yards at relatively high velocity. It is very dangerous and you should be 100+ yards away to be safe.

Very hard steel causes the soft bullets to turn almost into dust and come off of the flat face at about a 20 degree angle. These targets are safe to shoot at a much closer distance.

I purchased four targets from ShootSteel.com and installed on the old target stands.

The previous targets were suspended by chain which was welded at both ends. No problem. I have bolt cutters.

Uh… not as easy as I thought. The chain was really tough. By putting one handle against my chest and pulling on the other handle as hard as I could I could just barely cut through one side of the link. This didn’t leave a gap to disconnect the target. I had to cut the other side of the link to get the link apart. Two extremely difficult cuts per chain. This wasn’t the best solution.

I went back to my car and brought back my AR-15 with some M855 ammo. I got back about 20 yards and cut the chain with rifle fire:

20190421_101839

Much easier!

Here are the new targets.The two old targets on the right couldn’t be replaced easily so I just left them.

20190421_103134

Yes, it was very muddy. But the weather since then has been pretty good and the forecast is good. I’m expecting decent ground conditions and weather (cloudy with highs in the mid 50s) for Boomershoot 2019.

The new targets are not the ideal shapes. What I really wanted was seven inch squares and four inch squares to mimic Boomershoot targets. I could have had targets custom made but I ended up just purchasing off the shelf targets and painting them to mimic Boomershoot targets.

Here is one of the targets after being shot with my AR-15 with lead core bullets (the targets are rated for 30 caliber magnums at this range as well) from the shooting line:

20190421_174546Cropped

No craters!

2 thoughts on “New Boomershoot steel

Comments are closed.